Home > Products > 8.5 inch half-diameter 213mm tire width 83 unilateral finale 82 long shaft model
8.5-inch-half-diameter-213mm-tire-width-83-unilateral-finale-82-long-shaft-model-4.png
8.5-inch-half-diameter-213mm-tire-width-83-unilateral-finale-82-long-shaft-model-1.png
8.5-inch-half-diameter-213mm-tire-width-83-unilateral-finale-82-long-shaft-model-2.png
8.5-inch-half-diameter-213mm-tire-width-83-unilateral-finale-82-long-shaft-model-3.png
8.5-inch-half-diameter-213mm-tire-width-83-unilateral-finale-82-long-shaft-model-5.jpg

retail price:
$
Wholesale Price:
To be discussed
Customized price:
To be discussed
Custom made:
Tire
Fixed axis method
Wirewound resistor
Connectors
Wheels

Product Introduction

Custom go-kart tire and axle set: 10-inch specification (255mm diameter), 65mm wide tire for high wear resistance; 115mm long axle adopts a single-side axle structure, the axle diameter is precisely adapted to adult/youth karts, and no additional hole modification is required for installation. It supports batch customization to meet the purchasing needs of teams and venues!
Product Introduction
Installation Instructions
1. Connect the motor to the controller and power supply according to the wiring diagram on the controller.
2. The tire is installed outside the outer rotor hub.
3. When the power cord passes through metal parts, it should be protected by non-metal products.
4. Special attention: When the motor is powered on by the driver and the motor does not move or freezes, or it heats up abnormally quickly, the power must be turned off and on within three seconds to adjust the electrical angle or drive output to avoid motor failure

Product Parameters

Close
?